Browse Category



Set Up ITE2 NAS Static IP in PDM

What do you need to set up static IP?

Please try to think on one situation, if you always log in to your ITE2 NAS by IP address 192.168.0.XX.

Somehow in someday, you cannot connect to your NAS by IP address anymore, but ITE2 NAS works fine like usual, what is happening?

It may cause by the reason for the network device doesn’t work, or it may be the reason that your IP address has changed.

Someone may ask, what causes the IP address changed?

It is because ITE2 NAS will use assign IP address automatically, but if device encounter network device or ITE2 NAS reboot, under these two factors, IP address may have a chance to re-assign.

To solve this problem, we only need to set up static IP for ITE2 NAS! Sounds easy, right?

For operation steps, please refer to the following post!

Keep Reading

Windows 10 NAS route structure introduction

Windows 10 NAS route structure introduction:

ITE2 Technology Inc. ITE2 NAS adopt Windows 10 OS.

So in the ITE2 NAS PDM interface: File Management can be related to the local drive’s route, like [Local Disk: C] corresponds to [System Drive]; [Local Disk: D] correspond to [Main Space]; [Local Disk: E, F, G…] correspond to [Share Folder in Partition Drive].

In the following post, we will introduce each drive and it correspond relationship.

Keep Reading

Upgrade Capacity in Windows 10 NAS

What can ITE2 NAS user do if they run out of storage space and want to upgrade capacity for their NAS?

Here comes a great and easy solution that user can do!

Under the RAID 1, 5, 10, and other modes like that, we can use [Add hot spare] function.

This function not only can replace the damaged hard drive but also can replace the original hard drive with a larger one.

Please refer to the following introduction for more information.

 (Note: This function does not suitable for RAID 0 NAS).

Keep Reading

System Backup & Restore on Windows 10 NAS

When we are operating our Windows 10 NAS, if we want to reset system due to system display abnormal or slow, we can use the PDM interface system backup function.

Create a system backup first then restore the system if you need on the Windows 10 NAS desktop.

Moreover, system backup function can also restore all the PDM users and groups to the backup timing status.

So we highly recommend that Windows 10 NAS user should do the system backup after creating all the users and groups to avoid any system data loss.

For more information, please refer to the following system backup and restore introduction.


Keep Reading